Jump to content

Drilling system VS-1

Area of application

The drilling system VS-1 is designed for drilling short bores with diameters up to 50 mm and a maximum length of 12 m. The set is recommended for drilling bores for blasting when using anchoring technology in the underground building industry, mining industry, rehabilitation of concrete constructions, etc.

The size of the drilling system, as well as its weight makes it ideal for use in places that are small and difficult to access.

Description

Vrtací souprava VS-1The drilling system VS-1 consists of a bracing column on which a mount is attached for guiding the drilling hammer, which is fitted with a two-wheel chassis to make handling easier. In the rear of the mount there is a controller containing the main control elements.

The bracing column in the drilling system comprises a pneumatic cylinder with a double effective area in the direction of the ejection of the piston rod. On the bracing pneumatic cylinder there is a movable single-acting pneumatic cylinder where the sleeve travels on a toothed comb with the console for clamping the mount.

The drilling mount consists of a series connected set of two pneumatic cylinders. The main pneumatic cylinder consists of the body of the mount where the drilling hammer travels on the upper side. The auxiliary pneumatic cylinder located on the side of the mount causes the required longitudinal movement of the mount in the drilling direction. The mount can be tilted on the console at any angle.

The control panel on the drilling system enables centralized control of all the functions. The drilling set is designed so that it can be operated by one employee.
vs-1-nakres

The VL-01 drilling mount consists of connected set of two pneumatic cylinders. The main pneumatic cylinder is the body of the mount with a drilling hammer travelling on its upper side. The auxiliary pneumatic cylinder located on the side of the mount causes the required longitudinal movement of the mount in the drilling direction. The mount can be tilted on the console at any angle.

The control panel on the VS-1 drilling system enables centralized control of all its functions. The drilling set is designed so that it can be operated by one employee.

The air supply to the bracing pneumatic cylinder is fitted with a safety back-flow valve to secure the bracing column against release in the case of an unexpected interruption to the supply of compressed air.

The recommended type of drill hammer is the VKS-29 hammer supplied by the manufacturer.

Technical data

Parameter VS-1
Operating air pressure[MPa] 0,4–0,6
Air consumption[m3/min] 4
Range of column bracing (with set of supporting pins) [mm] 1710–3560
Total lift of the drilling hammer[mm] 2240
Maximum down pressure on the drilling hammer [N] 1450
Air supply DN 25
Height of the inserted bracing column [mm] 1710
Total length of the mount [mm] 2420
Weight of the set [kg] 180
Lift for the bracing pneumatic cylinder [mm] 1150
Max. down-pressure force of the bracing pneumatic cylinder [N] 2740
Range of the height of horizontal adjustment of the bore axis [mm] 645–2795
Movement of the hammer on the mount [mm] 1515
Longitudinal shift of the mount towards the bracing column [mm] 725

Photogallery

Photogallery – Practical application

Contact

Address:
ORTAS s. r. o.
Hate 546, 261 01 Pribram III
Czech Republic

Tel: +420 607 606 698
      +420 318 637 761
E-mail: info@ortas.cz